If your Cyclone Rake Collector isn't sitting properly on the chassis, a misplaced dump stud may be the reason. A small number of Cyclone Rake units were built with the dump stud positioned on the right side of the collector frame's center bar instead of the left. If that's the case with your unit, don't worry — the Collector Dump Bracket fixes this quickly and easily.
First, Check Your Collector
Lift up your Collector and take a look at where the dump stud is located on the center bar of the frame:
Dump stud on the LEFT side — You're all set. No bracket needed.
Dump stud on the RIGHT side — You'll need to install the Collector Dump Bracket.
If your dump stud is on the right side, download the installation instructions below. The process is straightforward and should only take a few minutes with basic hand tools.